Analytical Modelling of an Elevated-Tower Fibre-Optic Surveillance Platform: Coverage, Link Budget and Solar-Power Assessment
Keywords:
Elevated tower, Fibre-optic communication, Security surveillance, Geometric coverage, Optical link budget, Solar power system, Analytical modellingAbstract
This study presents the analytical modelling and performance evaluation of a low-altitude elevated-tower fibre-optic communication platform for security surveillance. The proposed platform integrates CCTV cameras, a thermal camera, AI-based motion detection, single-mode fibre-optic communication and a solar-powered energy system. System performance was evaluated at tower heights ranging from 10 m to 100 m. The modelled line-of-sight coverage radius increases from 11.29 km to 35.70 km, while the theoretical geometric coverage area expands from approximately 400 km² to 4,003 km². Camera ground viewing width increases from 11.55 m to 115.47 m, assuming a vertical field of view of 60° and a downward-facing camera. These coverage values represent theoretical geometric estimates rather than verified target-detection ranges. Estimated fibre attenuation ranges from 0.0035 dB to 0.035 dB for assumed fibre lengths of 10–100 m. The gross optical power budget is 28 dB, while the usable budget reduces to 23 dB after accounting for assumed component losses and an engineering margin, giving an adjusted theoretical maximum fibre distance of 65.71 km. Quantitative SNR and BER performance was not established because the required receiver and modulation parameters were not fully specified. The estimated average electrical load is 160 W, corresponding to a daily energy requirement of 3.84 kWh. A preliminary solar PV capacity of 1.2 kWp and battery capacity of approximately 10.1–15.2 kWh is proposed for 48–72 hours of autonomy. A tower height range of 60–70 m is identified as a candidate design option requiring further engineering validation
Published
How to Cite
Issue
Section
Copyright (c) 2026 Alade Olusope Micheal, Adewole Akinola Stephen, Adeniran Philip Adeyemi

This work is licensed under a Creative Commons Attribution 4.0 International License.
How to Cite
Most read articles by the same author(s)
- Michael Olusope Alade, Akinola Stephen Adewole, AI-Enabled Investigation of the Effect of PCB Thickness on Conversion Losses and Efficiency of a DC–DC Buck Converter Under Heatsink-Assisted Operation , Nigerian Journal of Physics: Vol. 35 No. 1 (2026): Nigerian Journal of Physics - Vol. 35 No. 1